Adjusting The Transport Belt Position - Canon Finisher-AB1 Service Manual

Chapter 5
5.3.2.6 Adjusting the Transport Belt
Position
Go through the following steps if you have replaced
the transport belt of the intermediate tray or there is
displacement among the sheets of a delivered stack:
1) Turn on the finisher.
2) Turn on the host machine so that it will be in a
standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-45
4) Remove the screw [2], and detach the switch
cover [1].
[2]
F-5-46
5-16
[1]
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
[1]
0015-2231
SW382
SW381
SW383
[1]
(-)
6) Press the push switch SW385 [1] to start
adjustment of the transport belt position.
SW382
SW381
SW383
(-)
7) Press the push switch SW383 [1] or SW384 [2] to
store the adjustment value.
A single press on SW383 will cause the LED to
indicate '-1', closing up the distance between the
belt [4] and the paper [5] and, thus, increasing the
retention by the belt. On the other hand, a single
press on SW384 will cause the LED to indicate
'+1', distancing the belt [4] and the paper [5] and,
thus, decreasing the retention by the belt. (range:
+4 to -4)
SW384 SW385
(+) ENTER
F-5-47
SW384 SW385
(+) ENTER
F-5-48
[1]