13) Remove the shift motor unit [1].
- 3 screws [2]
[1]
F-4-59
14) Remove the shift motor [1].
- 2 screws [2]
[1]
F-4-60
4.3.6 Belt Controller Unit
4.3.6.1 Before Removing the Belt
Controller Unit
1) Remove the stacking wall (upper). (page 4-
5)Reference[Removing
(upper)]
2) Remove the stacking wall (lower). (page 4-
5)Reference[Removing
(lower)]
3) Remove the handling tray unit. (page 4-
20)Reference[Removing the Handling Tray
Unit]
4) Remove the middle rear cover. (page 4-
6)Reference[Removing the Middle Rear Cover]
[2]
[2]
0015-2309
the
Stacking
Wall
the
Stacking
Wall
4.3.6.2 Removing the Belt Controller Unit
1) Loosen the screw [1].
[1]
F-4-61
2) Free the cable from the 4 clamps [1] and the edge
saddle [2]; then, disconnect the 3 connectors [3].
[1]
[3]
[2]
[3]
F-4-62
Chapter 4
0015-2310
[1]
[3]
[1]
4-15