Horizontal Registration Sensor Unit - Canon Finisher-AB1 Service Manual

Chapter 4
4.5.2.7 Removing the Static Eliminator
(T2)
1) Open the front cover.
2) Slide out the saddle unit.
3) Remove the static eliminator (T2) [1]
- 2 screws [2]
[1]
F-4-114
Points to Note When Mounting the Static
Eliminator
Don't mistake how to attach a static eliminator
needle.
F-4-115
4-30
[2]
4.5.3 Horizontal Registration Sensor
Unit
0015-2203
4.5.3.1 Before Removing the Horizontal
Registration Sensor Unit
1) Separate the machine from the host machine side.
(page 4-1)Reference[Disconnecting from the
Host Machine]
2) Remove the upper rear cover (right). (page 4-
2)Reference[Removing the Upper Rear Cover
(right)]
3) Remove the upper rear cover (left). (page 4-
3)Reference[Removing the Upper Rear Cover
(left)]
4) Remove the middle rear cover.
5) Remove the upper cover unit. (page 4-
3)Reference[Removing the Upper Cover Unit]
6) Remove the middle rear cover. (page 4-
6)Reference[Removing the Middle Rear Cover]
4.5.3.2 Removing the Horizontal
Registration Sensor Unit
1) Remove the fan unit [1].
- 1 connector [2]
- 2 screws [3]
[3]
[1]
F-4-116
0015-2205
0015-2206
[2]