Table of Contents
Advertisement
Main Menu
Supplemental Restraint System (SRS)
Dash Sensor Installation
CAUTION:
Be sure to install the harness wires so that they are
not pinched or interfering with other car parts.
Replace a sensor if it is dented, cracked or deformed.
For the SRS to function properly, the right and left
sensors must be installed on the proper sides.
1.
Be sure the battery cables are disconnected.
2.
Install the sensor securely.
3.
Remove the short connectors (RED) from the pas-
senger's airbag, and remove the SRS Service
Connector from the SRS main harness.
4.
Reconnect the passenger's airbag 3P connector to
the SRS main harness 3P connector, then reinstall
the glove box.
5.
Remove the short connector (RED) from the driver's
airbag, and remove the SRS Service Connector
from the cable reel.
Table of Contents
SENSOR BRACKET
DASH SENSOR
MOUNTING BOLTS
8 x 1.25 mm
22 N-m (2.2 kgf-m, 16 Ibf-ft)
Replace.
6. Reconnect the driver's airbag 3P connector to the
cable reel connector. Attach the short connector
(RED) to the access panel, then reinstall the panel
on the steering wheel.
7. Remove the short connectors (RED) from both seat
belt tensioners, then attach the short connectors
(RED) to their holders.
8. Reconnect the floor wire harness connectors to the
driver's and passenger's seat belt tensioners.
9. Reconnect the battery positive cable, then the
negative cable.
10. After installing the dash sensor, confirm proper sys-
tem operation:
Turn the ignition switch ON (II); the SRS indicator
light should come on for about six seconds and
then go off.
Advertisement
Chapters
Table of Contents
