Table of Contents
Advertisement
Main Menu
Supplemental Restraint System (SRS)
Seat Belt Tensioner Installation
CAUTION:
Be sure to install the harness wires so that they are
not pinched or interfering with other parts.
Be sure the battery cables are disconnected.
1.
Install the seat belt tensioner.
SEAT BELT
TENSIONER
MOUNTING BOLT
31 N-m (3.2 kgf-m, 23 Ibf-ft)
2.
Reinstall the shoulder harness anchor bolt.
3. Remove the short connector (RED) from the tension-
er, then connect the floor wire harness connector
to the tensioner.
SEAT BELT
TENSIONER
FLOOR WIRE HARNESS
3P CONNECTOR
Table of Contents
SHOULDER
HARNESS
ANCHOR BOLT
31 N-m (3.2 kgf-m,
23 Ibf-ft)
MOUNTING BOLT
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
4. Reinstall the rear pillar trim panel, rear side trim
panel, upper trim panel, and rear trim panel.
REAR PILLAR
TRIM PANEL
REAR SIDE TRIM
REAR TRIM
PANEL
PANEL
5. Remove the short connector (RED) from the passen-
ger's airbag, and remove the SRS Service
Connector from the SRS main harness.
6. Reconnect the passenger's airbag 3P connector to
the SRS main harness 3P connector, then reinstall
the glove box.
7. Remove the short connector (RED) from the driver's
airbag, and remove the SRS Service Connector A
from the cable reel connector.
8. Reconnect the driver's airbag 3P connector to the
cable reel 3P connector. Attach the short connector
(RED) to the access panel, then reinstall the panel
on the steering wheel.
9.
Reconnect the battery positive cable, then the nega-
tive cable.
10. After installing the seat belt tensioner, confirm
proper system operation.
Turn the ignition switch ON (II); the SRS indica-
tor light should come on for about six seconds
and then go off.
Confirm operation of the seat belt retractor.
UPPER
TRIM PANEL
Advertisement
Chapters
Table of Contents
