Installing The Mx2010 Standard Dc Cable Manager - Juniper MX2010 Hardware Manual

Figure 161: Reattaching the Sheet Metal Cover and EMI Door
1
2
7. Reattach any external devices connected to the craft interface.
RELATED DOCUMENTATION
MX2010 Craft Interface Description | 29
Maintaining and Verifying the Status of the MX2010 Craft Interface | 684

Installing the MX2010 Standard DC Cable Manager

To install the standard DC cable manager (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Position the DC cable manager over the two slots located on both sides of the DC PDM.
Figure 162 on page 369):
368