Spanning Tree Configuration Commands; Active Region-Configuration; Check Region-Configuration - H3C MSR Series Command Reference Manual

Spanning tree configuration commands

active region-configuration

Use active region-configuration to activate your MST region configuration.
Syntax
active region-configuration
Views
MST region view
Default command level
2: System level
Usage guidelines
When you configure MST region–related parameters, MSTP launches a new spanning tree
calculation process that might cause network topology instability. This is most likely to occur when
you configure the VLAN-to-instance mapping table. The launch will occur only after you activate the
MST region–related parameters by using the active region-configuration command or enable the
spanning tree feature by using the stp enable command.
H3C recommends that you use the check region-configuration command to determine whether
the MST region configurations to be activated are correct. Run this command only when they are
correct.
Examples
# Map VLAN 2 to MSTI 1 and manually activate the MST region configuration.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] instance 1 vlan 2
[Sysname-mst-region] active region-configuration
Related commands
•
instance
•
region-name
•
revision-level
•
vlan-mapping modulo
•

check region-configuration

check region-configuration
Use check region-configuration to display MST region pre-configuration information, including the
region name, revision level, and VLAN-to-instance mapping settings.
Syntax
check region-configuration
Views
MST region view
47