Display Poe Interface - HPE FlexNetwork 7500 Series Command Reference Manual
Network management and monitoring
Hide thumbs
Also See for FlexNetwork 7500 Series:
- Security configuration manual (597 pages) ,
- Network management and monitoring command reference (430 pages) ,
- Command reference manual (376 pages)
Table of Contents
Advertisement
Usage guidelines
Only the default MDC supports this command.
Examples
# Display general PSE information.
<Sysname> display poe device
PSE ID
Slot No. SSlot No. PortNum
1
Table 23 Command output
Field
PSE ID
Slot No.
SSlot No.
PortNum
MaxPower(W)
State
Model
display poe interface
Use display poe interface to display power supplying information for PIs.
Syntax
display poe interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface for the default MDC, this command displays power supplying information for all PIs. This
option is required for non-default MDCs.
Examples
# Display power supplying information for Ten-GigabitEthernet 1/0/1.
<Sysname> display poe interface gigabitethernet 1/0/1
PoE Status
0
0
48
MaxPower(W)
800
Description
ID of the PSE.
Slot number of the PSE.
Sub-slot number of the PSE.
Number of PIs on the PSE.
Maximum power of the PSE.
PSE status:
•
On—The PSE is supplying power.
•
Off—The PSE is not supplying power.
•
Faulty—The PSE has failed.
PSE model.
: Enabled
141
State
Model
Off
LSQ1GV48SD0
Advertisement
Table of Contents
