Mirroring-Group Reflector-Port - HPE FlexNetwork 7500 Series Command Reference Manual

<Sysname> system-view
[Sysname] mirroring-group 2 remote-destination
[Sysname] mirroring-group 2 monitor-port ten-gigabitethernet 1/0/2
# Create local mirroring group 3 and configure ports Ten-GigabitEthernet 1/0/1 through
Ten-GigabitEthernet 1/0/3 and Ten-GigabitEthernet 1/0/5 as its monitor ports.
<Sysname> system-view
[Sysname] mirroring-group 3 local
[Sysname] mirroring-group 3 monitor-port ten-gigabitethernet 1/0/1 to ten-gigabitethernet
1/0/3 ten-gigabitethernet 1/0/5
Related commands
mirroring-group

mirroring-group reflector-port

Use mirroring-group reflector-port to configure the reflector port for a remote source group.
Use undo mirroring-group reflector-port to restore the default.
Syntax
In system view:
mirroring-group group-id reflector-port interface-type interface-number
undo mirroring-group group-id reflector-port interface-type interface-number
In interface view:
mirroring-group group-id reflector-port
undo mirroring-group group-id reflector-port
Default
No reflector port is configured for a mirroring group.
Views
System view
Interface view
Predefined user roles
network-admin
mdc-admin
Parameters
group-id: Specifies a mirroring group by its number. The specified mirroring group must already exist.
The value range for this argument is 1 to 16.
interface-type interface-number: Specifies a port by its type and number.
Usage guidelines
You can configure reflector ports only for remote source groups.
The port to be configured as a reflector port must be a port not in use. Do not connect a network
cable to a reflector port.
When a port is configured as a reflector port, the port restores to the factory default settings. You
cannot configure other features on a reflector port.
326