Cwmp Enable; Display Cwmp Configuration - HPE FlexNetwork 7500 Series Command Reference Manual
Network management and monitoring
Hide thumbs
Also See for FlexNetwork 7500 Series:
- Security configuration manual (597 pages) ,
- Network management and monitoring command reference (430 pages) ,
- Command reference manual (376 pages)
Table of Contents
Advertisement
•
It specifies the amount of time the connection to the ACS can be idle before it is terminated. The
CPE terminates the connection to the ACS if no traffic is transmitted before the timer expires.
•
It also specifies the amount of time the CPE waits for the response to a session request. The
CPE determines that its session attempt has failed when the timer expires. By default, the CPE
retries a failed session until the session is established with the ACS. To limit the number of
retries, use the cwmp cpe connect retry command.
Examples
# Set the close-wait time to 60 seconds.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe wait timeout 60
Related commands
cwmp cpe connect retry
cwmp enable
Use cwmp enable to enable CWMP.
Use undo cwmp enable to disable CWMP.
Syntax
cwmp enable
undo cwmp enable
Default
CWMP is disabled.
Views
CWMP view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
CWMP configuration takes effect only after CWMP is enabled.
Examples
# Enable CWMP.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp enable
Related commands
cwmp
display cwmp configuration
Use display cwmp configuration to display the CWMP configuration.
Syntax
display cwmp configuration
450
Advertisement
Table of Contents
