Commit - HPE FlexNetwork 7500 Series Command Reference Manual

undo action number
Default
A monitor policy does not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
mdc-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
priority priority: Specifies the log severity level in the range of 0 to 7. A lower value represents a
higher severity level.
facility local-number: Specifies a logging facility by its facility number in the range of local0 to local7.
Facility numbers are used by a log host to identify log creation facilities for filtering log messages.
msg msg-body: Configures the log message body.
Usage guidelines
EAA sends log messages to the information center. You can configure the information center to
output these messages to certain destinations. For more information about the information center,
see "Configuring the information center."
You can configure a series of actions to be executed in response to the event specified in a monitor
policy. EAA executes the actions in ascending order of action IDs. When you add actions to a policy,
you must make sure the execution order is correct. If two actions have the same ID, the most recent
one takes effect.
When you define an action, you can specify a value or specify a variable name for an argument. For
more information about using EAA environment variables, see
Examples
# Configure an action for the CLI-defined policy test to send a log message "hello" with a severity of
7 from the facility device local3.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 syslog priority 7 facility local3 msg hello

commit

Use commit to enable a CLI-defined monitor policy.
Syntax
commit
Default
No CLI-defined monitor policies are enabled.
Views
CLI-defined policy view
Predefined user roles
network-admin
"rtm
244
environment."