Mirroring-Group Monitor-Port (System View) - HPE FlexNetwork 7500 Series Command Reference Manual
Network management and monitoring
Hide thumbs
Also See for FlexNetwork 7500 Series:
- Security configuration manual (597 pages) ,
- Network management and monitoring command reference (430 pages) ,
- Command reference manual (376 pages)
Table of Contents
Advertisement
# Create remote destination group 2 and configure Ten-GigabitEthernet 1/0/2 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-destination
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] mirroring-group 2 monitor-port
Related commands
mirroring-group
mirroring-group monitor-port (system view)
Use mirroring-group monitor-port to configure the monitor ports for a mirroring group.
Use undo mirroring-group monitor-port to remove the monitor ports from a mirroring group.
Syntax
mirroring-group group-id monitor-port interface-list
undo mirroring-group group-id monitor-port interface-list
Default
No monitor port is configured for a mirroring group.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
group-id: Specifies a mirroring group by its number. The specified mirroring group must already exist.
The value range for this argument is 1 to 16.
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
You can configure monitor ports only for local mirroring groups and remote destination groups.
Do not enable the spanning tree feature on the monitor port of a mirroring group.
For a Layer 2 aggregate interface configured as the monitor port of a mirroring group, do not perform
any of the following tasks:
•
Configure its member ports as source ports of the mirroring group.
Use a monitor port only for port mirroring, so the data monitoring device receives only the mirrored
traffic.
The member port of an existing mirroring group cannot be configured as a monitor port.
The member port of an aggregate interface cannot be configured as a monitor port.
Examples
# Create local mirroring group 1 and configure Ten-GigabitEthernet 1/0/1 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] mirroring-group 1 monitor-port ten-gigabitethernet 1/0/1
# Create remote destination group 2 and configure Ten-GigabitEthernet 1/0/2 as its monitor port.
325
Advertisement
Table of Contents
