Poe Priority - HPE FlexNetwork 7500 Series Command Reference Manual

poe power max-value max-power
undo poe power max-value
In IRF mode:
poe power chassis chassis-number max-value max-power
undo poe power chassis chassis-number max-value
Default
The maximum PoE power is the total maximum power of all operating power modules in the power
frame.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
max-power: Sets the maximum PoE power in watts. The value is an integer in the range of 0 to the
total maximum power of all operating power modules in the power frame. To accommodate transient
peak power surges, the actual maximum power available is 5% higher than the configured maximum
power.
chassis chassis-number: Specifies an IRF member by its ID. (In IRF mode.)
Usage guidelines
Only the default MDC supports this command.
The configured maximum PoE power must be smaller than the rated PoE power.
Examples
# Set the maximum PoE power to 2000 watts.
<Sysname> system-view
[Sysname] poe power max-value 2000
Related commands
poe max-power
poe max-power (system view)

poe priority

Use poe priority to set the power supply priority for a PI.
Use undo poe priority to restore the default.
Syntax
poe priority { critical | high | low }
undo poe priority
Default
The power supply priority of a PI is low.
Views
PI view
160