GigabitEthernet1/0/3
The output shows that GigabitEthernet 1/0/4 and GigabitEthernet 1/0/3 belong to the same group
and must be assigned to the same MDC at the same time. To assign both interfaces to MDC sub1,
use the following command:
[Sysname-mdc-2-sub1] allocate interface gigabitethernet 1/0/3 gigabitethernet 1/0/4
Configuration of the interfaces will be lost. Continue? [Y/N]:y
display mdc
Use display mdc to display MDCs and their status.
Syntax
display mdc [ name mdc-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
name mdc-name: Specifies an MDC by its name, a case-insensitive string of 1 to 15 characters. If
you do not specify this option, the command displays all MDCs.
Examples
# Display all MDCs.
<Sysname> display mdc
ID
1
2
Table 11 Command output
Field
Status
Related commands
mdc
display mdc interface
Use display mdc interface to display the interfaces of MDCs.
Name
Status
Admin
active
sub1
inactive
Description
Status of the MDC:
•
inactive—The MDC is stopped or not started yet.
•
starting—The device is executing the mdc start command to start the MDC.
•
active—The MDC is operating correctly.
•
updating—The device is executing the location command to authorize the
MDC to use an LPU.
•
stopping—The device is executing the undo mdc start command to stop the
MDC.
GigabitEthernet1/0/4
45