Netconf Commands; Netconf Capability Specific-Namespace; Netconf Idle-Timeout - HPE FlexNetwork 7500 Series Command Reference Manual

NETCONF commands

The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for
features, commands, and parameters might differ in FIPS mode and non-FIPS mode. For more
information about FIPS mode, see Security Configuration Guide.

netconf capability specific-namespace

Use netconf capability specific-namespace to configure the device to use module-specific
namespaces.
Use undo netconf capability specific-namespace to restore the default.
Syntax
netconf capability specific-namespace
undo netconf capability specific-namespace
Default
The device uses the common namespace.
Views
System view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
NETCONF supports both the common namespace and module-specific namespaces. The common
namespace is incompatible with module-specific namespaces. To set up a NETCONF session, the
device and the client must use the same type of namespaces. By default, the common namespace is
used. If the client does not support the common namespace, use this command to configure the
device to use module-specific namespaces.
For this command to take effect, you must reestablish the NETCONF session.
Examples
# Configure the device to use module-specific namespaces.
<Sysname> system-view
[Sysname] netconf capability specific-namespace

netconf idle-timeout

Use netconf idle-timeout to set the NETCONF session idle timeout time.
Use undo netconf idle-timeout to restore the default.
Syntax
netconf { soap | agent } idle-timeout minute
undo netconf { soap | agent } idle-timeout
Default
The NETCONF session idle timeout time is 10 minutes for NETCONF over SOAP over HTTP
sessions and NETCONF over SOAP over HTTPS sessions.
231