Mirroring-Group Remote-Probe Vlan - HPE FlexNetwork 7500 Series Command Reference Manual

If an IRF port is bound to only one physical interface, do not configure the physical interface as a
reflector port. Otherwise, the IRF might split.
You can configure a port as a reflector port only when the port is operating with the default setting of
the following parameters:
•
Duplex mode.
•
Speed.
•
MDI settings.
You cannot change the duplex mode, MDI settings, or speed for a reflector port.
The member port of an aggregate interface can be configured as a reflector port.
Examples
# Create remote source group 1. Configure Ten-GigabitEthernet 1/0/1 as its reflector port in system
view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 reflector-port ten-gigabitethernet 1/0/1
This operation may delete all settings made on the interface. Continue? [Y/N]: y
# Create remote source group 2. Configure Ten-GigabitEthernet 1/0/2 as its reflector port in interface
view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] mirroring-group 2 reflector-port
This operation may delete all settings made on the interface. Continue? [Y/N]: y
Related commands
mirroring-group

mirroring-group remote-probe vlan

Use mirroring-group remote-probe vlan to specify a VLAN as the remote probe VLAN for a
mirroring group.
Use undo mirroring-group remote-probe vlan to restore the default.
Syntax
mirroring-group group-id remote-probe vlan vlan-id
undo mirroring-group group-id remote-probe vlan vlan-id
Default
No remote probe VLAN is configured for a mirroring group.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
group-id: Specifies a mirroring group by its number. The specified mirroring group must already exist.
The value range for this argument is 1 to 16.
327