HPE FlexNetwork 7500 Series Command Reference Manual page 368
Network management and monitoring
Hide thumbs
Also See for FlexNetwork 7500 Series:
- Security configuration manual (597 pages) ,
- Network management and monitoring command reference (430 pages) ,
- Command reference manual (376 pages)
Table of Contents
Advertisement
mdc-operator
Parameters
slot slot-number: Specifies a card by its slot number. If you do not specify a card, the command
displays IPv6 NetStream template information for the active MPU. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command displays
IPv6 NetStream template information for the global active MPU. (In IRF mode.)
Usage guidelines
IPv6 NetStream templates vary by aggregation mode. This command displays IPv6 NetStream
template information for all the configured aggregation modes.
Examples
# Display IPv6 NetStream template information.
<Sysname> display ipv6 netstream template
Flow template refresh frequency
Flow template refresh interval
Active flow templates
Created flow templates
Protocol-port outbound template:
Template ID
Field count
Field type
---------------------------------------------------------------------------
Flows
Out packets
Out bytes
First forwarded
Last forwarded
Protocol
IP protocol version
Direction
PAD
L4 source port
L4 destination port
Sampling algorithm
PAD
PAD
PAD
Sampling interval
Protocol-port inbound template:
Template ID
Field count
Field type
---------------------------------------------------------------------------
Flows
In packets
: 20
: 30 min
: 2
: 2
: 3258
: 14
Field length (bytes)
4
8
8
4
4
1
1
1
1
2
2
1
1
1
1
4
: 3257
: 14
Field length (bytes)
4
8
358
Advertisement
Table of Contents
