Cwmp Cpe Inform Interval - HPE FlexNetwork 7500 Series Command Reference Manual

undo cwmp cpe connect retry
Default
The CPE retries a failed connection until the connection is established with the ACS.
Views
CWMP view
Predefined user roles
network-admin
mdc-admin
Parameters
retries: Specifies the maximum number of CWMP connection retries. The value range is 0 to 100. To
disable the CPE to retry a CWMP connection, set this argument to 0.
Usage guidelines
The CPE retries connecting to the ACS when its initial connection attempt fails or the CWMP session
is ended before the CPE receives a session closed message from the ACS. The CPE does not stop
its connection retry attempts until the connection is established or the number of connection retries
reaches the upper limit.
Examples
# Set the maximum number of CWMP connection retries to 5.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe connect retry 5

cwmp cpe inform interval

Use cwmp cpe inform interval to set the periodic Inform interval.
Use undo cwmp cpe inform interval to restore the default.
Syntax
cwmp cpe inform interval interval
undo cwmp cpe inform interval
Default
The periodic Inform interval is 600 seconds.
Views
CWMP view
Predefined user roles
network-admin
mdc-admin
Parameters
interval: Sets the periodic Inform interval in the range of 10 to 86400 seconds.
Usage guidelines
This command sets the interval for the CPE to send Inform messages automatically to the ACS. For
the command to take effect, you must configure the cwmp cpe inform interval enable command.
444