Ip Netstream Export Template Refresh-Rate - HPE FlexNetwork 7500 Series Command Reference Manual

Default
The packets take the IP address of the output interface as the source IP address.
Views
System view
NetStream aggregation mode view
Predefined user roles
network-admin
mdc-admin
Parameters
interface-type interface-number: Specifies a source interface by its type and number.
Usage guidelines
The IP address of the specified source interface is used as the source IP address for packets sent to
NetStream servers.
You can configure different source interfaces in different NetStream aggregation mode views.
If no source interface is configured in a NetStream aggregation mode view, the source interface in
system view applies.
Examples
# In system view, specify Ten-GigabitEthernet 1/0/1 as the source interface for NetStream traditional
data packets.
<Sysname> system-view
[Sysname] ip netstream export source interface ten-gigabitethernet 1/0/1
# In destination-prefix aggregation mode view, specify Ten-GigabitEthernet 1/0/2 as the source
interface for NetStream aggregation data packets.
<Sysname> system-view
[Sysname] ip netstream aggregation destination-prefix
[Sysname-ns-aggregation-dstpre] ip netstream export source interface ten-gigabitethernet
1/0/2
Related commands
ip netstream aggregation

ip netstream export template refresh-rate

Use ip netstream export template refresh-rate to set the refresh rate for the NetStream version 9
or version 10 template.
Use undo ip netstream export template refresh-rate to restore the default.
Syntax
ip netstream export template refresh-rate { packet packets | time minutes }
undo ip netstream export template refresh-rate { packet | time }
Default
The packet count-based refresh rate is 20 packets, and the time-based refresh interval is 30
minutes.
Views
System view
346