Ipv6 Netstream Export Template Refresh-Rate - HPE FlexNetwork 7500 Series Command Reference Manual

undo ipv6 netstream export source
Default
The packets take the IPv6 address of the output interface as the source IPv6 address.
Views
System view
IPv6 NetStream aggregation mode view
Predefined user roles
network-admin
mdc-admin
Parameters
interface-type interface-number: Specifies a source interface by its type and number for the IPv6
NetStream data export.
Usage guidelines
You can configure different source interfaces in different IPv6 NetStream aggregation mode views.
If no source interface is configured in IPv6 NetStream aggregation mode view, the source interface in
system view applies.
As a best practice, connect the management Ethernet interface to a NetStream server, and configure
the interface as the source interface.
Examples
# In system view, specify Ten-GigabitEthernet 1/0/1 as the source interface for IPv6 NetStream
traditional data packets.
<Sysname> system-view
[Sysname] ipv6 netstream export source interface ten-gigabitethernet 1/0/1
# In destination-prefix aggregation mode view, specify Ten-GigabitEthernet 1/0/2 as the source
interface for IPv6 NetStream aggregation data packets.
<Sysname> system-view
[Sysname] ipv6 netstream aggregation destination-prefix
[Sysname-ns6-aggregation-dstpre] ipv6 netstream export source interface
ten-gigabitethernet 1/0/2
Related commands
ipv6 netstream aggregation

ipv6 netstream export template refresh-rate

Use ipv6 netstream export template refresh-rate to set the refresh rate for the IPv6 NetStream
version 9 or version 10 template.
Use undo ipv6 netstream export template refresh-rate to restore the default.
Syntax
ipv6 netstream export template refresh-rate { packet packets | time minutes }
undo ipv6 netstream export template refresh-rate { packet | time }
Default
The packet count-based refresh rate is 20 packets, and the time-based refresh interval is 30
minutes.
365