Action Switchover; Action Syslog - HPE FlexNetwork 7500 Series Command Reference Manual

[Sysname-rtm-test] action 3 reboot slot 1

action switchover

Use action switchover to add an active/standby switchover action to a monitor policy.
Use undo action to remove an action.
Syntax
action number switchover
undo action number
Default
A monitor policy does not contain any actions.
Views
CLI-defined policy view
Predefined user roles
network-admin
mdc-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
Usage guidelines
You can configure a series of actions to be executed in response to the event specified in a monitor
policy. EAA executes the actions in ascending order of action IDs. When you add actions to a policy,
you must make sure the execution order is correct. If two actions have the same ID, the most recent
one takes effect.
(In standalone mode.) This command does not trigger an active/standby switchover in either of the
following situations:
•
The device has only one MPU.
•
The standby MPU is not in up state.
(In IRF mode.) This command does not trigger an active/standby switchover in either of the following
situations:
•
No global standby MPU is configured.
•
The global standby MPU is not in up state.
Examples
# Configure an action for the CLI-defined policy test to perform an active/standby switchover.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] action 3 switchover

action syslog

Use action syslog to add a Syslog action to a monitor policy.
Use undo action to remove an action.
Syntax
action number syslog priority priority facility local-number msg msg-body
243