Info-Center Synchronous - HPE FlexNetwork 7500 Series Command Reference Manual
Network management and monitoring
Hide thumbs
Also See for FlexNetwork 7500 Series:
- Security configuration manual (597 pages) ,
- Network management and monitoring command reference (430 pages) ,
- Command reference manual (376 pages)
Table of Contents
Advertisement
Parameters
module-name: Specifies a module by its name. You can use the info-center source ? command to
view the modules supported by the device.
default: Specifies all supported modules.
console: Outputs logs to the console.
logbuffer: Outputs logs to the log buffer.
logfile: Outputs logs to the log file.
loghost: Outputs logs to the log host.
monitor: Outputs logs to the monitor terminal.
deny: Disables log output.
level severity: Specifies a severity level in the range of 0 to 7. The smaller the severity value, the
higher the severity level. See
higher levels are allowed or denied to be output.
Usage guidelines
If you do not set an output rule for a module, the module uses the output rule set by using the default
keyword. If no rule is set by using the default keyword, the module uses the default output rule.
To modify or remove an output rule set for a module, you must use the module-name argument. A
new output rule configured by using the default keyword does not take effect on the module.
If you execute this command for a module multiple times, the most recent configuration takes effect.
If you execute this command for the default modules multiple times, the most recent configuration
takes effect.
Examples
# Output only VLAN module's information with the emergency level to the console.
<Sysname> system-view
[Sysname] info-center source default console deny
[Sysname] info-center source vlan console level emergency
# Based on the previous configuration, disable output of VLAN module's information to the console
so no system information is output to the console.
<Sysname> system-view
[Sysname] undo info-center source vlan console
info-center synchronous
Use info-center synchronous to enable synchronous information output.
Use undo info-center synchronous to disable synchronous information output.
Syntax
info-center synchronous
undo info-center synchronous
Default
Synchronous information output is disabled.
Views
System view
Table 86
for more information. Logs at the specified severity level and
400
Advertisement
Table of Contents
