Display Poe Interface - HPE FlexNetwork 5130 HI Series Network Management And Monitoring Command Reference

Table 23 Command output
Field
Slot
PSE ID
Slot No.
SSlot No.
PortNum
MaxPower(W)
State
Model

display poe interface

Use display poe interface to display power supplying information for PIs.
Syntax
display poe interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays power supplying information for all PIs.
Examples
# Display power supplying information for GigabitEthernet 1/0/1.
<Sysname> display poe interface gigabitethernet 1/0/1
PoE Status
Power Priority
Oper
IEEE Class
Detection Status
Power Mode
Current Power
Average Power
Peak Power
Max Power
Electric Current
Voltage
Description
IRF member device ID.
ID of the PSE.
Slot number of the PSE.
Sub-slot number of the PSE.
Number of PIs on the PSE.
Maximum power of the PSE.
PSE status:
• On—The PSE is supplying power.
• Off—The PSE is not supplying power.
• Faulty—The PSE has failed.
PSE model.
: Enabled
: Low
: Off
: 0
: Disabled
: Signal
: 0 mW
: 0 mW
: 0 mW
: 30000 mW
: 0 mA
: 0.0 V
132