Cwmp Cpe Wait Timeout - HPE FlexNetwork 7500 Series Command Reference Manual

Views
CWMP view
Predefined user roles
network-admin
mdc-admin
Parameters
username: Specifies a username, a case-sensitive string of 1 to 255 characters.
Usage guidelines
You can configure only one username for the ACS to authenticate to the CPE when it initiates a
connection. If you execute this command multiple times, the most recent configuration takes effect.
For a successful connection, make sure the ACS has the same username setting as the CPE. If a
password is required, you must also make sure the ACS has the same password setting as the CPE.
The ACS must provide the correct username when it initiates a connection to the CPE. If the
username is incorrect, the CPE denies the connection request from the ACS.
Examples
# Configure the username used for authenticating the ACS.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe username newname
Related commands
cwmp cpe password

cwmp cpe wait timeout

Use cwmp cpe wait timeout to set the close-wait timer for the CPE to close an idle connection.
Use undo cwmp cpe wait timeout to restore the default.
Syntax
cwmp cpe wait timeout seconds
undo cwmp cpe wait timeout
Default
The close-wait timer is 30 seconds.
Views
CWMP view
Predefined user roles
network-admin
mdc-admin
Parameters
seconds: Sets the close-wait timer, in the range of 30 to 1800 seconds.
Usage guidelines
The close-wait timer has the following functions:
449