HPE FlexNetwork 7500 Series Command Reference Manual page 441
Network management and monitoring
Hide thumbs
Also See for FlexNetwork 7500 Series:
- Security configuration manual (597 pages) ,
- Network management and monitoring command reference (430 pages) ,
- Command reference manual (376 pages)
Table of Contents
Advertisement
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Usage guidelines
This command displays VCF fabric topology information only when it is executed on the master
spine node.
Before you display VCF fabric topology information, make sure VCF fabric topology discovery and
automated underlay network deployment are enabled.
Examples
# Display VCF fabric topology information.
<Sysname> display vcf-fabric topology
----------------------------------------------------------------------------------
* indicates the master spine role among all spines
SpineIP
*10.11.113.51
Table 98 Command output
Field
SpineIP
Interface
Link
LeafIP
Status
Related commands
vcf-fabric underlay autoconfigure
vcf-fabric topology enable
Topology Information
Interface
Ten-GigabitEthernet1/0/1
Ten-GigabitEthernet1/0/2
Ten-GigabitEthernet1/0/3
Description
IPv4 address of the management Ethernet interface on the spine node.
This field displays an asterisk (*) before the IP address if the device is the
master spine node.
Interface through which the spine node connects to a leaf node.
If the device is a master spine node, all interfaces on the device are
displayed.
Physical link state of the interface.
IPv4 address of the interface through which a leaf node connects to the
spine node.
Status of automated underlay network deployment on the leaf node.
This field displays two hyphens (--) if automated underlay network
deployment is not started.
This field displays Deploying if automated underlay network deployment
is in progress.
Link LeafIP
Up
10.11.113.52
Down --
Down --
431
Status
Deploying
--
--
Advertisement
Table of Contents
