Poe Pd-Description - HPE FlexNetwork 7500 Series Command Reference Manual

undo poe mode
Default
The PoE power transmission mode is signal (power over signal cables).
Views
PI view
PoE profile view
Predefined user roles
network-admin
mdc-admin
Parameters
signal: Specifies the PoE power transmission mode as power over signal cables. The system uses
pairs 1, 2, 3, and 6 in the Category 3 or Category 5 twisted pair cable to supply DC power.
spare: Specifies the PoE power transmission mode as power over spare cables. The system uses
pairs 4, 5, 7, and 8 in the Category 3 or Category 5 twisted pair cable to supply DC power. The device
does not support this mode.
Examples
# Set the PoE power transmission mode to power over signal cables in PI view.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] poe mode signal
# Set the PoE power transmission mode to power over signal cables in PoE profile view.
<Sysname> system-view
[Sysname] poe-profile abc
[Sysname-poe-profile-abc-1] poe mode signal
Related commands
poe-profile

poe pd-description

Use poe pd-description to configure a description for the PD that connects to a PI.
Use undo poe pd-description to restore the default.
Syntax
poe pd-description text
undo poe pd-description
Default
No description is configured for the PD that connects to a PI.
Views
PI view
Predefined user roles
network-admin
mdc-admin
158