HPE FlexNetwork 7500 Series Command Reference Manual page 365

Field
Type DstIP(Port) SrcIP(Port)
TC FlowLbl If(Direct) Pkts
DstMAC(VLAN) SrcMAC(VLAN)
TopLblType(IP/MASK)
Description
Statistics of the active flows in the current cache:
•
Flow type. Flows are classified into the following types:




•
Destination IPv6 address (destination port).
•
Source IPv6 address (source port).
•
Protocol number.
Pro
•
Traffic classification.
•
Flow label.
•
Interface name (direction).
•
Number of packets.
ICMPv6 packets do not contain port number fields, so the type
and code fields are captured. The value for the destination port
represents these two fields:
•
The highest 8 bits represent the type field.
•
The lowest 8 bits represent the code field.
The value for the source port is set to 0 and does not indicate
any statistics.
Layer 2 information for the active flows in the current cache:
•
Destination MAC address.
•
Destination VLAN ID.
•
Source MAC address.
•
Source VLAN ID.
This field is not supported in the current software version.
Information about the active MPLS flows in the current cache:
•
Type of the labels at the top of the label stack:


Lbl-Exp-S-List
•
Label list:



355
IP flows.
Layer 2 flows with IPv6 protocol information (IPL2).
MPLS flows without IP options (MPLS). This field is not
supported in the current software version.
MPLS flows with IP options (IP&MPLS). This field is
not supported in the current software version.
IP address associated with the label.
Mask associated with the label.
Lbl—20-bit label value.
Exp—3-bit field for implementing QoS.
S—1-bit bottom of stack flag. The S field is set to 1 if
the label is the bottom label and set to 0 if not.