Display Logbuffer - HPE FlexNetwork 7500 Series Command Reference Manual

Log buffer: Enabled
Max buffer size 1024, current buffer size 512,
Current messages 0, dropped messages 0, overwritten messages 0
Log file: Enabled
Security log file: Enabled
Information timestamp format:
Log host: Date
Other output destination: Date

display logbuffer

Use display logbuffer to display the state of the log buffer and the log information in the log buffer.
Syntax
In standalone mode:
display logbuffer [ reverse ] [ level severity | size buffersize | slot slot-number ] *
In IRF mode:
display logbuffer [ reverse ] [ level severity | size buffersize | chassis chassis-number slot
slot-number ] *
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
reverse: Displays log entries chronologically, with the most recent entry at the top. If you do not
specify this keyword, the command displays log entries chronologically, with the oldest entry at the
top.
level severity: Specifies a severity level in the range of 0 to 7. If you do not specify a severity level,
this command displays log information for all levels.
Table 86 Log levels
Severity
value
0
1
2
3
4
Level Description
The system is unusable. For example, the system
Emergency
authorization has expired.
Action must be taken immediately. For example, traffic
Alert
on an interface exceeds the upper limit.
Critical condition. For example, the device temperature
Critical exceeds the upper limit, the power module fails, or the
fan tray fails.
Error Error condition. For example, the link state changes.
Warning condition. For example, an interface is
Warning
disconnected, or the memory resources are used up.
380
Keyword in
commands
emergency
alert
critical
error
warning