Allen-Bradley Kinetix 6200 User Manual page 59

3. Guide the control module mounting studs so they engage with the
Mounting Stud
(right side)
Mounting Hook
(right side)
2094-SE02F-M00-Sx
or 2094-EN02D-M01-Sx
4. Pivot the control module toward the power module to engage the signal
Guide Pin Alignment on
Either Side of Tongue
2094-SE02F-M00-Sx
or 2094-EN02D-M01-Sx
5. Tighten the captive screw.
(apply 1.1 N•m (10.0 lb•in) torque)
2094-SE02F-M00-Sx
or 2094-EN02D-M01-Sx
6. Repeat
Rockwell Automation Publication 2094-UM002G-EN-P - August 2016
Mount the Kinetix 6200 and Kinetix 6500 Drive System
power module hooks.
Control Module
connectors and guide pins.
Control Module
Captive Screw
Control Module
step 2 through step 5
and AM power module installed on your Bulletin 2094 power rail.
IAM or AM Power Module
(IAM power module is shown)
Left-side mounting stud and
hook are hidden from view.
IAM or AM Power Module
(IAM power module is shown)
Guide Pins
Straddling Tongue
Mounting Stud and
Hook Engaged
(right side)
Left-side mounting stud and
hook are hidden from view.
IAM or AM Power Module
(IAM power module is shown)
to mount a control module onto each IAM
Chapter 3
59