Allen-Bradley Kinetix 6200 User Manual page 56

Chapter 3 Mount the Kinetix 6200 and Kinetix 6500 Drive System
Power Rail
56
2. Determine the next available slot and module for mounting.
3. Hang the mounting bracket from the slot on the power rail.
Power Rail Slot
Slots for additional axis modules,
shunt module, or slot-filler modules.
4. Pivot module downward and align the guide pins on the power rail with
the guide pin holes in the back of the module.
IAM or AM Power Module, IPIM,
Shunt, or Slot-filler Module, Rear View
(AM power module is shown)
Rockwell Automation Publication 2094-UM002G-EN-P - August 2016
ATTENTION: To avoid damage to the pins on the back of each IAM,
AM, IPIM, shunt, and slot-filler module and to make sure that
module pins mate properly with the power rail, hang modules as
shown in step 3 through step
The power rail must be mounted vertically on the panel before
hanging modules on the power rail. Do not mount modules if the
power rail is horizontal.
Mounting Bracket
Pivot module downward
and align with guide pins.
Guide Pin
Holes
Power rail (side view)
in upright vertical position.
Shunt, or Slot-filler Module, Side View
6.
IAM or AM Power Module, IPIM,
Shunt, or Slot-filler Module
(IAM power module is shown)
Guide Pins
IAM or AM Power Module, IPIM,
(IAM power module is shown)