Allen-Bradley Kinetix 6200 User Manual page 275

Table 123 - Load Observer Gain Parameters
IDN Name
P:0:432 Load Observer Bandwidth (Kop)
P:0:433 Load Observer Integral Bandwidth (Koi) Rad/s
P:0:434 Load Observer Feedback Gain (Kof)
The Acceleration Estimate and Torque Estimate signals are read by using
IDN-435 and P-436, respectively. Definitions for these IDN parameters are
given in the following table.
Table 124 - Load Observer Output Signals
IDN Name
P:0:435 Load Observer Acceleration Estimate
P:0:436 Load Observer Torque Estimate
When load observer and the torque low-pass filter are both enabled, and the
low-pass filter bandwidth is less than 5 times the load observer bandwidth,
their interaction can interfere with each other, causing instability. The low-pass
filter is always limited to a bandwidth under 400 Hz in drive firmware.
IDN P-065 can be used to override the torque low-pass filter bandwidth
limiting. The filter is also bypassed if the override IDN P-065 is set to 1 and the
torque low-pass filter bandwidth is set to zero.
Table 125 - Torque Low-pass Filter Bandwidth
IDN
Bandwidth in the Logix
Designer Application
P:0:065
= 0
0
> 0
= 0
1
> 0
Refer to Appendix F on
parameter values with read/write messages in the Logix Designer application.
Rockwell Automation Publication 2094-UM002G-EN-P - August 2016
Configure the Load Observer Feature
Units Format
Rad/s
16 bit
unsigned int
–
Units Format
32bit
Acceleration
signed int
16 bit
Torque
signed int
Actual Bandwidth in Drive
400 Hz
Limited to ≤ 400 Hz
Filter bypassed
Limited to ≤ 10,430 Hz
page 307 for more information on changing IDN
Appendix D
Value, min Value, max
12,500
65,535
0
200
Value, min Value, max
31 31
-2 2 -1
15 15
-2 2 -1
275