A-2
Errors (Events) That Can Occur in
Connected Devices
The section provides tables of the errors (events) that can occur in the devices connected to an NY-
series Industrial PC.
Refer to 3-1 Interpreting Tables for interpreting error tables.
A-2-1
Errors in Slave Terminals
The section provides tables of the errors (events) that can occur in the following Units in OMRON Slave
Terminals.
• NX-series EtherCAT Coupler Units
• NX-series Digital I/O Units
• NX-series Analog I/O Units
• NX-series System Units
• NX-series Position Interface Units
• NX-series Communications Interface Units
• NX-series Safety Control Units
• NX-series Load Cell Input Units
• NX-series IO-Link Master Units
NX-series EtherCAT Coupler Units
The section provides a table of the errors (events) that can occur in the following Unit.
NX-ECC
The manual names are given below for the catalog numbers given in the Reference column of the
event table.
Cat. No.
W519
Event code
Event name
00210000 hex
Bus Control-
ler Error
00220000 hex
Non-volatile
Memory
Hardware
Error
05010000 hex
ESC Error
05020000 hex
ESC Initial-
ization Error
NY-series Troubleshooting Manual (W564)
NX-series EtherCAT Coupler Unit User's Manual
Meaning
Assumed cause
An internal bus
• A Unit failed or an I/O commu-
error occurred.
nications error occurred
between the Communications
Coupler Unit and the NX Unit.
An error occurred in
• Non-volatile memory failure
non-volatile mem-
ory.
An error occurred in
• An error occurred in the Ether-
the EtherCAT slave
CAT slave communications
communications
controller.
controller.
Initialization of the
• An initialization error occurred
EtherCAT slave
in the EtherCAT slave commu-
communications
nications controller.
controller failed.
Manual name
Level
Maj
Prt
Min
Obs Info
S
S
S
S
Appendix
A
Reference
W519
W519
W519
W519
A-19