Omron NY532-5400 Troubleshooting Manual page 231

Event name Socket Handle Out of Range
Meaning The handle that is specified for the socket service instruction is not correct.
PLC Function Module
Source
Error attri-
Level
butes
Effects User program
System- Variable
defined
None
variables
Assumed cause
The handle that is specified for
the socket service instruction is
not correct.
Cause and
correction
Attached Information 1: Error Location
Attached Information 2: Error Location Details (Rung Number). For a program section, the rung number
from the start of the section is given. For ST, the line number is given.
Attached
Attached Information 3: Names of the Instruction and Instruction Instance Where the Error Occurred. If
information
there is more than one possible instruction, information is given on all of them. Nothing is given if the
instruction cannot be identified.
Attached Information 4: Expansion Error Code (ErrorIDEx)
Precautions/ If a program is changed after an error occurs, the attached information that is displayed may not be cor-
Remarks rect.
NY-series Troubleshooting Manual (W564)
Source details
Observation
Recovery
Continues.
Operation
Data type
---
Correction
Correct the socket handle for the
instruction to the handle that was
obtained with one of the following
instructions.
• SktUDPCreate instruction
• SktTCPConnect instruction
• SktTCPAccept instruction
3 Error Descriptions and Corrections
Event code 54012007 hex
Instruction Detection
timing
---
Log category
The relevant instruction will end according to speci-
fications.
Name
---
Prevention
Specify handles that are obtained
with the following instructions.
• SktUDPCreate instruction
• SktTCPConnect instruction
• SktTCPAccept instruction
At instruction
execution
System
3
3-155