Omron NY532-5400 Troubleshooting Manual page 650

Appendix
Event code Event name
56070000 hex Target Posi-
tion Setting
Out of Range
56080000 hex Impossible
CNC Motor
Operation
Specified
when the
Servo is OFF
56090000 hex Target Veloc-
ity Setting
Out of Range
560A0000 hex Accelera-
tion/Deceler-
ation Setting
Out of Range
560B0000 hex Travel Mode
Selection Out
of Range
560C 0000 hex Immediate
Stop Instruc-
tion Executed
560D 0000 hex Parameter
Selection Out
of Range
560E0000 hex CNC Param-
eter Setting
Read/Write
Setting Value
Out of Range
560F 0000 hex CNC Param-
eter Setting
Read/Write
Target Out of
Range
56100000 hex Cycle Start
Error with
Undefined
Home
A-4
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Position input vari- input variable. Or, there was an
able to a CNC overflow/underflow in the tar-
instruction is out of get position.
range.
An operation • An operation instruction was
instruction was exe- executed for the CNC motor for
cuted for the CNC which the Servo is OFF.
motor for which the
• Home was preset with the
Servo is OFF.
CNC_Home or CNC_HomeW-
ithParameter instruction for an
axis for which EtherCAT pro-
cess data communications are
not established.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Velocity input vari- input variable.
able to a CNC
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Acceleration input input variable.
variable to a CNC
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MoveMode input input variable.
variable to a CNC
instruction is out of
range.
An Immediate Stop • An Immediate Stop instruction
(CNC_ImmediateS- was executed.
top) instruction was
executed.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
ParameterNumber input variable.
input variable to a
CNC instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
SettingValue in-out in-out variable.
variable to a CNC
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Target in-out vari- in-out variable.
able to a CNC
instruction is out of
range.
A cycle start was • A cycle start was executed for a
executed for a CNC CNC coordinate system includ-
coordinate system ing the positioning axis with no
including the posi- defined home.
tioning axis with no
defined home.
Level
Maj Prt Min Obs Info
S O030
O030
S
O030
S
S O030
S O030
S O030
O030
S
O030
S
S O030
S O030
NY-series Troubleshooting Manual (W564)
Reference