Omron NY532-5400 Troubleshooting Manual page 134

3 Error Descriptions and Corrections
Event name Firmware Configuration Mismatch
Meaning An inconsistency was detected in the software which configures the firmware.
PLC Function Module
Source
Error attri-
Level
butes
Effects User program
System- Variable
defined vari-
None
ables
Assumed cause
The firmware upgrade is not com-
pleted.
Cause and
correction
The firmware was partially
restored using the Rescue disk.
An HDD or a SSD was replaced.
Attached Attached information 1: The name and version of the software in which an inconsistency occurred.
information
Precau- None
tions/Remarks
*1 Refer to I/O Operation for Major Fault Level Controller Errors on page 1-14 for details.
Event name PLC System Processing Error
Meaning A fatal error was detected in the PLC Function Module.
PLC Function Module
Source
Error attri-
Level
butes
Effects User program
System- Variable
defined
None
variables
Assumed cause
Cause and
An error occurred in the software. Contact your OMRON represen-
correction
Attached Attached information 1: System information
information
Precautions/ None
Remarks
* For details, refer to I/O Operation for Major Fault Level Controller Errors on page 1-14.
3-58
Source details
Major fault
Recovery
Stops.
Operation
Data type
---
Correction
Upgrade the firmware again.
Restore the whole system using
the Rescue disk.
Source details
Major fault
Recovery
Stops.
Operation
Data type
---
Correction
tative.
Event code 10120000 hex
None Detection tim-
ing
Cycle the
Log category
power supply.
*1
Stops.
Name
---
Prevention
None
None
Event code 4003 0000 hex
None Detection
timing
Cycle the
Log category
power supply.
*
Stops.
Name
---
Prevention
None
NY-series Troubleshooting Manual (W564)
At power ON or
Controller reset
System
Continuously
System