Omron NY532-5400 Troubleshooting Manual page 365

Track Option Structure ON Compensation Setting
Event name
Out of Range
The value of OnCompensation that is specified in the TrackOptions in-out variable to a motion control
Meaning
instruction is out of range.
PLC Function Module
Source
Error attri-
Level
butes
Effects User program
System- Variable
defined
_MC_AX[*].Obsr.Active
variables
Assumed cause
The value of the member of the
Cause and
structure variable that was speci-
correction
fied for the in-out variable of the
instruction is out of range.
Attached Information 1: Error Location
Attached Information 2: Error Location Details (Rung Number). For a program section, the rung number
from the start of the section is given. For ST, the line number is given.
Attached
Attached Information 3: Name of the Instruction and Instruction Instance Where the Error Occurred. If
information
there is more than one possible instruction, information is given on all of them. Nothing is given if the
instruction cannot be identified.
Attached Information 4: Expansion Error Code (ErrorIDEx)
Precautions/ If a program is changed after an error occurs, the attached information that is displayed may not be cor-
Remarks rect.
NY-series Troubleshooting Manual (W564)
Source details
Observation
Recovery
Continues.
Operation
Data type
BOOL
Correction
Correct the value of the member
of the structure variable that is
specified for the in-out variable of
the relevant instruction so that it
is in the valid range.
3 Error Descriptions and Corrections
54015729 hex
Event code
Instruction Detection
timing
---
Log category
The relevant instruction will end according to speci-
fications.
Name
Axis Observation Occurrence
Prevention
Make sure that the value of the
member of the structure variable
that is specified for the in-out vari-
able of the relevant instruction is
in the valid range.
At instruction
execution
System
3
3-289