Omron NY532-5400 Troubleshooting Manual page 412

3 Error Descriptions and Corrections
Event code Event name
54670000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(Position
Type)
54680000 hex Unused Axis
Specification
for Master
Axis
54690000 hex First Position
Setting Out of
Range
546A0000 hex Last Position
Setting Out of
Range
546B0000 hex Illegal
First/Last
Position Size
Relationship
(Linear
Mode)
546C 0000 hex Master Sync
Start Posi-
tion Setting
Out of Range
546D 0000 hex Slave Sync
Start Posi-
tion Setting
Out of Range
3-336
Meaning Assumed cause
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
ReferenceType re-execution was changed.
input variable when
re-executing a
motion control
instruction. (This
input variable can-
not be changed
when re-executing
an instruction.)
The master axis • The master axis specified for a
specified for a motion control instruction is an
motion control unused axis.
instruction is an
unused axis.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
FirstPosition input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
LastPosition input input variable.
variable to a motion
control instruction is
out of range.
The parameter • The value of the LastPosition
specified for the input parameter is less than the
LastPosition input value of the FirstPosition input
variable to a motion variable for the instruction when
control instruction is the Count Mode is set to Linear
smaller than the Mode.
parameter speci-
fied for the FirstPo-
sition input variable.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MasterSyncPosi- input variable.
tion input variable
to a motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
SlaveSyncPosition input variable.
input variable to a
motion control
instruction is out of
range.
Level
Maj Prt Min Obs Info
S page 3-435
S page 3-435
S page 3-436
S page 3-436
S page 3-437
S page 3-437
S page 3-438
NY-series Troubleshooting Manual (W564)
Reference