Omron NY532-5400 Troubleshooting Manual page 495

Latch ID Selection Out of Range for Trigger Input
Event name
Condition
The parameter specified for the TriggerInput::LatchID input variable to a motion control instruction is out of
Meaning
range.
Motion Control Function Module
Source
Error attri-
Level
butes
Effects User program
System- Variable
defined
_MC_AX[*].MFaultLvl.Active
variables
Assumed cause
Instruction input parameter
Cause and
exceeded the valid range of the
correction
input variable.
Attached None
information
Precautions/ None
Remarks
Event name Setting Out of Range for Writing MC Setting
Meaning The parameter specified for the SettingValue input variable to a motion control instruction is out of range.
Motion Control Function Module
Source
Error attri-
Level
butes
Effects User program
Variable
System-
defined
_MC_COM.MFaultLvl.Active
variables
Assumed cause
Instruction input parameter
exceeded the valid range of the
Cause and input variable.
correction
The parameter specification and
the data type of the setting value
do not agree.
Attached None
information
Precautions/ None
Remarks
NY-series Troubleshooting Manual (W564)
Source details
Minor fault
Recovery
Continues.
Operation
Data type
BOOL
Correction
Correct the parameter so that the
valid range of the input variable is
not exceeded for the relevant
instruction.
Source details
Minor fault
Recovery
Continues. Operation
Data type
BOOL
Correction
Correct the parameter so that the
valid range of the input variable is
not exceeded for the relevant
instruction.
Make corrections so that the
parameter settings and the data
types of the settings agree.
3 Error Descriptions and Corrections
544E0000 hex
Event code
Axis Detection
timing
Error reset
Log category
Operation is not possible for relevant axis. Relevant
axis decelerates to a stop if it is in motion.
Name
Axis Minor Fault Occurrence
Prevention
Set the input parameter to the
instruction so that the valid range
of the input variable is not
exceeded.
Event code 544F 0000 hex
MC Common Detection
timing
Error reset
Log category
The relevant instruction is not executed.
Name
MC Common Minor Fault Occur-
rence
Prevention
Set the input parameter to the
instruction so that the valid range
of the input variable is not
exceeded.
Make sure the parameter settings
and the data type of the setting
values agree.
At instruction
execution
System
3
At instruction
execution
System
3-419