Omron NY532-5400 Troubleshooting Manual page 651

Event code Event name
56110000 hex Homing
Parameter
Setting Out of
Range
56120000 hex M Code
Number Out
of Range
56130000 hex CNC Instruc-
tion Re-exe-
cution
Disabled
(CNC Coordi-
nate System
Specification)
56140000 hex CNC Instruc-
tion Re-exe-
cution
Disabled
(Logical CNC
Motor Num-
ber)
56150000 hex Illegal NC
Program
56160000 hex Cycle Start
Multi-execu-
tion Disabled
56170000 hex Impossible
CNC Motor
Cycle Start
Specified
when the
Servo is OFF
56180000 hex Illegal NC
Program
Number
Specification
NY-series Troubleshooting Manual (W564)
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
HomingParameter in-out variable.
in-out variable to a
CNC instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MCodeNo input input variable.
variable to a CNC
instruction is out of
range.
An attempt was • A parameter for an in-out vari-
made to change the able that cannot be changed for
parameter for the re-execution was changed.
Coord in-out vari-
able when re-exe-
cuting a CNC
instruction. (This in-
out variable cannot
be changed when
re-executing an
instruction.)
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
parameter for the re-execution was changed.
LogicalMotorNo
input variable when
re-executing a CNC
instruction. (This
input variable can-
not be changed
when re-executing
an instruction.)
An error was • NC program transfer process-
detected in the NC ing failed.
program transferred
from Sysmac Stu-
dio.
A cycle start was • A cycle start was executed
executed multiple while the CNC coordinate sys-
times for the same tem is Executing (Executing),
target (CNC coordi- MovingOnHold (Manual Opera-
nate system). tion While Holding), or Moving
(Moving).
A cycle start was • A cycle start was executed for
executed for a CNC the CNC motor for which Servo
coordinate system is turned OFF.
including the CNC
motor for which the
Servo is OFF.
The NC program • A cycle start was executed after
specified for Pro- an unloaded NC program is
gramNo in the Con- specified for ProgramNo in the
trolInputs in-out ControlInputs in-out variable to
variable to the the CNC_CoordControl instruc-
CNC_CoordCon- tion.
trol instruction is not
loaded.
Level
Maj Prt Min Obs Info
S O030
O030
S
O030
S
O030
S
O030
S
S O030
S O030
S O030
Appendix
Reference
A
A-5