Connection With The Sysmac Studio; Configurations That Allow Online Connections - Omron NY532-1*00-112*13**0 User Manual

2-4

Connection with the Sysmac Studio

This section describes the configurations to connect the Sysmac Studio to an IPC Machine Controller.
2-4-1

Configurations That Allow Online Connections

You can connect online from the Sysmac Studio to the built-in EtherNet/IP port of the NY-series Box
PC.
Connect with EtherNet/IP
1:1 Connection
Sysmac Studio
EtherNet/IP
Built-in EtherNet/IP port
•
A direct connection is made from the computer that
runs Sysmac Studio. You do not need to specify the
IP address or connection device.
•
You can make the connection either with or without
an Ethernet switch.
•
You can use either a cross cable or a straight cable.
Connect to EtherNet/IP through USB
You can connect to the NY-series built-in EtherNet/IP port through a USB port of an NJ/NX-series Con-
troller.
Connect a computer and the NJ/NX-series CPU Unit with a USB 2.0 certified cable. Do not use a USB
hub to connect them.
Sysmac Studio
USB
NJ/NX-series Controller
NY-series Industrial Box PC Hardware User's Manual (W556)
EtherNet/IP
NY-series PC
2 System Configurations
1:N Connections
Sysmac Studio
EtherNet/IP
Built-in EtherNet/IP port
•
Specify the IP address of the remote node from the
Sysmac Studio.
•
You can use either a cross cable or a straight cable.
NY-series PC
2
2 - 7