Other Errors (Events) That Can Occur In The Cpu Units; A-1-1 Errors In Cnc Function; Errors In Cnc Function - Omron NY532-5400 Troubleshooting Manual

Appendix
A-1 Other Errors (Events) That Can
Occur in the CPU Units
This section provides tables of the errors (events) that can occur in the specific model of an NY-series
CPU Unit. These errors are not provided in Section 3 Error Descriptions and Corrections. Refer to 3-1
Interpreting Tables for interpreting error tables.
A-1-1

Errors in CNC Function

This section provides tables of the errors (events) that can occur in the CNC functions and CNC instruc-
tions.
You can use the CNC functions and CNC instructions with an NY532-5400 Controller. The unit version
of the Controller is 1.16 or later.
CNC Function
The manual names are given below for the catalog numbers given in the Reference column of the
event table.
Cat. No.
O030
Event code Event name
47810000 hex CNC Param-
eter Setting
Invalid
1780 0000 hex CNC Param-
eter Setting
Error
17810000 hex Absolute
Encoder
Home Offset
Read Error
17820000 hex CNC Motor
Compensa-
tion Table
Read Error
37800000 hex Required
Process Data
Object Not
Set
A-2
NJ/NY-series NC Integrated Controller User's Manual
Meaning Assumed cause
A fatal error was • The system failed to transfer
detected during set- the CNC parameter setting.
ting of the CNC Otherwise, an error occurred in
Function Module. the software.
The CNC parame- • The power supply to the Con-
ters that were troller was interrupted or com-
saved in non-vola- munications with the Sysmac
tile memory are Studio were disconnected while
missing. downloading the CNC parame-
ter settings or clearing memory.
• Non-volatile memory failure
The absolute • When the retained variables
encoder current are backed up with a battery,
position that is this event indicates that the life
retained during of the battery in the CPU Unit
power interruptions has expired.
was lost.
• Backup memory failure
The CNC motor • The power supply to the Con-
compensation table troller was interrupted or com-
that was saved in munications with the Sysmac
non-volatile mem- Studio were disconnected while
ory is missing. downloading the CNC parame-
ter settings or clearing memory.
• Non-volatile memory failure
The object that is • The required PDOs are not
required for the mapped when the assigned
assigned axis type axis type in the CNC motor
in the CNC motor parameter settings is set to a
parameter settings servo axis or encoder axis.
is not allocated to
• Non-volatile memory failure
PDO.
Manual name
Level
Maj Prt Min Obs Info
S
S
S
S
S
NY-series Troubleshooting Manual (W564)
Reference
O030
O030
O030
O030
O030