Omron NY532-5400 Troubleshooting Manual page 585

Event name IP Address Setting Error
Meaning An error was detected in the IP address settings.
EtherNet/IP Function Module
Source
Error attri-
Level
butes
Effects User program
NET RUN
Status
Stop
System- Variable
defined
_EIP1_IPAdrCfgErr
variables
Assumed cause
Parameter error
Power was interrupted when a
download was in progress for the
Cause and built-in EtherNet/IP port settings.
correction
The IP address acquired from
BOOTP server is illegal.
A memory error occurred.
Attached information 1: Type of errors (01 hex: Non-volatile memory access error, 02 hex: Inconsistency
in settings)
Attached
Attached information 2: Error details (00 hex: Non-volatile memory access error)
information
When the settings are inconsistent
(11 hex: Illegal IP address, 12 hex: Illegal subnet mask)
Precautions/ The cause of error can be identified with the attached information.
Remarks
NY-series Troubleshooting Manual (W564)
Source details
Minor fault
Recovery
Continues.
Operation
NET ERR
Error
Data type
BOOL
Correction
Identify the error from the
attached information, correct the
setting, and then download the
settings again.
Perform the Clear All Memory
operation or download the set-
tings again.
Correct the IP address that was
provided to this port by the
BOOTP server so that it is within
the range specified for an NX-
series Controller.
If operation is not recovered by
the above, replace the CPU Unit.
3 Error Descriptions and Corrections
Event code 34290000 hex
Communica-
Detection
tions port
timing
1/Internal port 1
Automatic
recovery (after
downloading
the settings), Log category
cycle the power
supply, or reset
Controller.
EtherNet/IP communications are not possible for
the relevant communications port.
LINK
---
Name
Port1 IP Address Setting Error
Prevention
None
Do not turn OFF the power sup-
ply to the Controller while a
download is in progress for the
built-in EtherNet/IP port settings.
Correct the IP address that was
provided to this port by the
BOOTP server so that it is within
the range specified for an NX-
series Controller.
None
At power ON or
Controller reset
System
3
3-509