Omron NY532-5400 Troubleshooting Manual page 663

Event code Event name
54015624 hex Number of
NC Program
Exceeded
54015625 hex Illegal CNC
Motor Speci-
fication
54015626 hex Illegal CNC
Motor Com-
pensation
Table Specifi-
cation
54015628 hex Illegal Load
NC Program
54016783 hex Target Posi-
tion Positive
Software
Limit
Exceeded
54016784 hex Target Posi-
tion Negative
Software
Limit
Exceeded
54016785 hex Command
Position
Over-
flow/Under-
flow
54016786 hex Positive Limit
Input
NY-series Troubleshooting Manual (W564)
Meaning Assumed cause
Loading failed • A new NC program was loaded
because an attempt while the number of loaded NC
was made to load programs reaches the maxi-
NC programs over mum.
the maximum num-
ber of NC pro-
grams.
The CNC motor • A CNC motor does not exist for
specified for the the variable specified for the
Target in-out Target input variable to the
variable to a CNC instruction.
instruction is not
exist.
The CNC motor • A CNC motor compensation
compensation table table does not exist for the vari-
specified for the able specified for the Target
Target input vari- input variable to the instruction.
able to a CNC
instruction is not
exist.
An error was • A syntax error was detected in
detected in the the NC program you made an
loaded NC pro- attempt to load.
gram.
The specified posi- • The parameter specified for the
tion exceeds the Position input variable to the
positive software instruction is beyond the posi-
limit. tive software limit.
• The first position is beyond the
positive software limit and an
instruction that specifies motion
in the opposite direction of the
software limit was executed.
The specified posi- • The parameter specified for the
tion exceeds the Position input variable to the
negative software instruction is beyond the nega-
limit. tive software limit.
• The first position is beyond the
negative software limit and an
instruction that specifies motion
in the opposite direction of the
software limit was executed.
Positioning, an • One of the following was exe-
instruction in the cuted when there was a com-
underflow/overflow mand position
direction, or an overflow/underflow.
instruction for which
• A positioning instruction
the direction is not
• A continuous control instruc-
specified was exe-
tion in the underflow/overflow
cuted when there
direction
was an under-
• An instruction for which the
flow/overflow in the
direction is not specified
command position.
(syncing)
An instruction was • An instruction for a motion in
executed for a the positive direction was exe-
motion in the posi- cuted when the positive limit
tive direction when input was ON, or an instruction
the positive limit for a motion with no direction
input was ON. specification was executed
when the positive limit input
was ON.
Level
Maj Prt Min Obs Info
S O030
O030
S
O030
S
O030
S
S O030
S O030
O030
S
S O030
Appendix
Reference
A
A-17