Omron NY532-5400 Troubleshooting Manual page 111

Event code Event name
5401545C hex Motion Control
Instruction Re-exe-
cution Disabled
(MasterStartDis-
tance)
5401545D hex Motion Control
Instruction Re-exe-
cution Disabled
(Continuous)
5401545E hex Motion Control
Instruction Re-exe-
cution Disabled
(MoveMode)
5401545F hex Illegal Auxiliary
Axis Specification
54015460 hex Illegal Axis Specifi-
cation
54015461 hex Illegal Axes Group
Specification
54015462 hex Illegal Master Axis
Specification
NY-series Troubleshooting Manual (W564)
Meaning
An attempt was made to • A parameter for an
change the parameter for
the MasterStartDistance
input variable when re-exe-
cuting a motion control
instruction. (This input vari-
able cannot be changed
when re-executing an
instruction.)
An attempt was made to • A parameter for an
change the parameter for
the Continuous input vari-
able when re-executing a
motion control instruction.
(This input variable cannot
be changed when re-exe-
cuting an instruction.)
An attempt was made to • A parameter for an
change the parameter for
the MoveMode input vari-
able when re-executing a
motion control instruction.
(This input variable cannot
be changed when re-exe-
cuting an instruction.)
The axis specified for the • An axis does not exist
Auxiliary input variable to a
motion control instruction
does not exist.
The axis specified for the • An axis does not exist
Axis input variable to a
motion control instruction
does not exist.
The axes group specified • An axes group does
for the AxesGroup input
variable to a motion control
instruction does not exist or
is not a used group.
• The axes group speci-
The axis that is specified • An axis does not exist
for the Master input vari-
able to a motion control
instruction is not correct.
• The axis that was
• The master axis and a
3 Error Descriptions and Corrections
Assumed cause
Maj Prt
input variable that
cannot be changed for
re-execution was
changed.
input variable that
cannot be changed for
re-execution was
changed.
input variable that
cannot be changed for
re-execution was
changed.
for the variable speci-
fied for the Auxiliary
input variable to the
instruction.
for the variable speci-
fied for the Axis input
variable to the instruc-
tion.
not exist for the vari-
able specified for the
AxesGroup input vari-
able to the instruction.
fied for the AxesGroup
input variable to the
instruction is not spec-
ified as a used group.
for the variable speci-
fied for the Master
input variable to the
instruction.
specified for the Mas-
ter input variable to
the MC_Phasing (Shift
Master Axis Phase)
instruction is not the
master axis for sync-
ing.
slave axis are not
assigned to the same
task.
Level
Refer-
ence
Min Obs Info
S page 3-231
S page 3-232
S page 3-233
S page 3-234
S page 3-234
S page 3-235
S page 3-236
3-35
3