Omron NY532-5400 Troubleshooting Manual page 474

3 Error Descriptions and Corrections
Event name Path Selection Out of Range
Meaning The parameter specified for the PathChoice input variable to a motion control instruction is out of range.
Motion Control Function Module
Source
Error attri-
Level
butes
Effects User program
Variable
System-
defined
_MC_GRP[*].MFaultLvl.Active
variables
Assumed cause
Instruction input parameter
Cause and
exceeded the valid range of the
correction
input variable.
Attached None
information
Precautions/ None
Remarks
Event name Position Type Selection Out of Range
The parameter specified for the ReferenceType input variable to a motion control instruction is out of
Meaning
range.
Motion Control Function Module
Source
Error attri-
Level
butes
Effects User program
Variable
System-
_MC_COM.MFaultLvl.Active
defined
variables
_MC_AX[*].MFaultLvl.Active
Assumed cause
Instruction input parameter
Cause and
exceeded the valid range of the
correction
input variable.
Attached None
information
Precautions/ None
Remarks
3-398
Source details
Minor fault
Recovery
Continues.
Operation
Data type
BOOL
Correction
Correct the parameter so that the
valid range of the input variable is
not exceeded for the relevant
instruction.
Source details
Minor fault
Recovery
Continues.
Operation
Data type
BOOL
BOOL
Correction
Correct the parameter so that the
valid range of the input variable is
not exceeded for the relevant
instruction.
Event code 542F 0000 hex
Axes group Detection
timing
Error reset
Log category
Operation is not possible for relevant axes group.
Relevant axes group decelerates to a stop if it is in
motion.
Name
Axes Group Minor Fault Occur-
rence
Prevention
Set the input parameter to the
instruction so that the valid range
of the input variable is not
exceeded.
Event code 5430 0000 hex
MC common or Detection
axis timing
Error reset
Log category
Operation is not possible for relevant axis. Relevant
axis decelerates to a stop if it is in motion.
Name
MC Common Minor Fault Occur-
rence
Axis Minor Fault Occurrence
Prevention
Set the input parameter to the
instruction so that the valid range
of the input variable is not
exceeded.
NY-series Troubleshooting Manual (W564)
At instruction
execution
System
At instruction
execution
System