Omron NY532-5400 Troubleshooting Manual page 613

Hide thumbs Also See for NY532-5400:

Table of Contents

Attached information 1: Error location diagnostic result

Attached information 2: Node address of the slave which the frame from the slave that is connected to the

output port is not received. (Only if the attached information 1 is 1.)

Attached information 3: Port name of the slave output port which the frame from the slave that is con-

nected is not received. (Only if the attached information 1 is 1.)

Attached information 4: System information

Precautions/

If the node address setting of an EtherCAT slave is not made, the node address cannot be identified from

the attached information. Check that there is no error for each slave and cable.

NY-series Troubleshooting Manual (W564)

0: Error location is not identified

1: Error location is identified

Not 0: Node address of the slave

• If the network configuration information agrees with the physical network information

of the relevant slave, the port name that is displayed on the Support Software is out-

put. If they do not agree, any one of PortA, PortB, PortC, and PortD is output as the

default of a port name.

• If the attached information 2 is 0, 0 is output as the port name.

3 Error Descriptions and Corrections

Chapters

Table of Contents