The Instruction Was Executed For; Correct The Program So That The Mc_Changeaxisuse (Change Axis Use) Instruction Is Executed; After The Specified Axis Is; Changed To An Unused Axis - Omron NY532-5400 Troubleshooting Manual

3 Error Descriptions and Corrections
Event name Cannot Write Axis Parameters
Meaning The instruction was executed for an axis that is not an unused axis.
PLC Function Module
Source
Error attri-
Level
butes
Effects User program
Variable
System-
defined
_MC_COM.MFaultLvl.Active
variables
Assumed cause

The instruction was executed for

Cause and
a used axis or an undefined axis.
correction
Attached Information 1: Error Location
Attached Information 2: Error Location Details (Rung Number).
For a program section, the rung number from the start of the section is given. For ST, the line number is
Attached given.
information
Attached Information 3: Names of the Instruction and Instruction Instance Where the Error Occurred. If
there is more than one possible instruction, information is given on all of them. Nothing is given if the
instruction cannot be identified.
Attached Information 4: Expansion Error Code (ErrorIDEx)
Precautions/ If a program is changed after an error occurs, the attached information that is displayed may not be cor-
Remarks rect.
3-298
Source details
Observation
Recovery
Continues.
Operation
Data type
BOOL
Correction
Correct the program so that the
MC_ChangeAxisUse (Change
Axis Use) instruction is executed

after the specified axis is

changed to an unused axis.

Event code 5401 573A hex
Instruction Detection
timing
---
Log category
The relevant instruction will end according to speci-
fications.
Name
MC Common Minor Fault Occur-
rence
Prevention
Write the program so that the
specified axis is an unused axis

when the instruction is executed.

NY-series Troubleshooting Manual (W564)
At instruction
execution
System