Omron NY532-5400 Troubleshooting Manual page 404

3 Error Descriptions and Corrections
Event code Event name
54300000 hex Position Type
Selection Out
of Range
54310000 hex Travel Mode
Selection Out
of Range
54320000 hex Transition
Mode Selec-
tion Out of
Range
54330000 hex Continue
Method
Selection Out
of Range
54340000 hex Combine
Mode Selec-
tion Out of
Range
54350000 hex Synchroniza-
tion Start
Condition
Selection Out
of Range
54360000 hex Master and
Slave
Defined as
Same Axis
54370000 hex Master and
Auxiliary
Defined as
Same Axis
54380000 hex Mas-
ter/Slave
Axis Num-
bers Not in
Ascending
Order
3-328
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
ReferenceType input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MoveMode input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
TransitionMode input variable.
input variable to a
• _mcAborting or _mcBuffered
motion control
was specified for BufferMode
instruction is out of
and _mcTMCornerSuperim-
range.
posed was specified for Transi-
tionMode.
The value of the • The value of the reserved input
reserved input vari- variable Continuous changed.
able Continuous to
a motion control
instruction
changed.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
CombineMode input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
LinkOption input input variable.
variable to a motion
control instruction is
out of range.
The same axis is • The parameter is the same for
specified for the the Master and Slave input vari-
Master and Slave
ables to the instruction.
input variables to a
motion control
instruction.
The same axis is • The parameter is the same for
specified for the the Master and Auxiliary input
Master and Auxil- variables to the instruction.
iary input variables
to a motion control
instruction.
The axis numbers • The parameters for the Master
specified for the and Slave input variables to the
Master and Slave instruction were not in ascend-
input variables to a ing order when _mcLatestCom-
motion control mand was specified for the
instruction are not ReferenceType input variable to
in ascending order. the instruction.
Level
Maj Prt Min Obs Info
S page 3-398
S page 3-399
S page 3-400
S page 3-400
S page 3-401
S page 3-401
S page 3-402
S page 3-402
S page 3-403
NY-series Troubleshooting Manual (W564)
Reference