Omron NY532-5400 Troubleshooting Manual page 90

3 Error Descriptions and Corrections
Instructions
This section provides a table of errors (events) that occur for instructions. The lower four digits of the
event code give the error code for the instruction. For descriptions of the error codes, refer to the
descriptions of the corresponding event codes. For example, if the error code of the instruction is
16#0400, refer to the description of the event with event code 54010400 hex.
Event code Event name
54010400 hex Input Value Out of
Range
54010401 hex Input Mismatch
54010402 hex Floating-point
Error
54010403 hex BCD Error
54010404 hex Signed BCD Error
54010405 hex Illegal Bit Position
Specified
3-14
Meaning
An input parameter for an • An input parameter for
instruction exceeded the
valid range for an input
variable. Or, division by an
integer of 0 occurred in divi-
sion or remainder calcula-
tions.
The relationship for the • The relationship for an
instruction input parame-
ters did not meet required
conditions. Or, a numeric
value during or after
• A value when pro-
instruction execution did
not meet conditions.
Non-numeric data was • Non-numeric data was
input for a floating-point
number input parameter to
an instruction.
A value that was not BCD • A hexadecimal digit of
was input for a BCD input
parameter to an instruction.
An illegal value was input • An illegal value was
for the most significant digit
for a signed BCD input
parameter to an instruction.
The bit position specified • The bit position speci-
for an instruction was ille-
gal.
Assumed cause
Maj Prt
an instruction
exceeded the valid
range for an input vari-
able. Or, division by an
integer of 0 occurred
in division or remain-
der calculations.
input parameter did
not meet required con-
ditions.
cessing an instruction
or in the result does
not meet the condi-
tions.
input for a floating-
point number input
parameter to an
instruction.
A, B, C, D, E, or F was
input for a BCD input
parameter to an
instruction.
input for the most sig-
nificant digit for a
signed BCD input
parameter to an
instruction.
• The most-signifi-
cant digit was 2 to F
when _BCD0 was
specified as the
BCD format.
• The most-signifi-
cant digit was A, B,
C, D, or E when
_BCD2 was speci-
fied as the BCD for-
mat.
• The most-signifi-
cant digit was B, C,
D, or E when
_BCD3 was speci-
fied as the BCD for-
mat.
fied for an instruction
exceeds the data
range.
NY-series Troubleshooting Manual (W564)
Level
Refer-
ence
Min Obs Info
S page 3-
102
S page 3-
103
S page 3-
104
S page 3-
104
S page 3-105
S page 3-106