Omron NY532-5400 Troubleshooting Manual page 417

Event code Event name
54920000 hex Enable Exter-
nal Latch
Instruction
Execution
Disabled
54930000 hex Master Axis
Offset Out of
Range
54940000 hex Slave Axis
Offset Out of
Range
54950000 hex Command
Current Posi-
tion Count
Selection Out
of Range
54960000 hex Master Axis
Gear Ratio
Numerator
Out of Range
54970000 hex Master Axis
Gear Ratio
Denominator
Out of Range
54980000 hex Auxiliary Axis
Gear Ratio
Numerator
Out of Range
54990000 hex Auxiliary Axis
Gear Ratio
Denominator
Out of Range
549A0000 hex Master Axis
Position Type
Selection Out
of Range
NY-series Troubleshooting Manual (W564)
Meaning Assumed cause
_mcImmediateStop • _mcImmediateStop was speci-
was specified for fied for the StopMode input
the StopMode input variable when the MC_Touch-
variable when the Probe (Enable External Latch)
MC_TouchProbe instruction was executed in
(Enable External Drive Mode for an encoder axis.
Latch) instruction
was executed in
Drive Mode for an
encoder axis.
The parameter • The instruction input parameter
specified for the exceeded the range of signed
MasterOffset input 40-bit data when it is converted
variable to a motion to pulses.
control instruction is
out of range.
The parameter • The instruction input parameter
specified for the exceeded the range of signed
SlaveOffset input 40-bit data when it is converted
variable to a motion to pulses.
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
CmdPosMode input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
RatioNumerator- input variable.
Master input vari-
able to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
RatioDenominator- input variable.
Master input vari-
able to a motion
control instruction is
out of range.
• Instruction input parameter
The parameter
exceeded the valid range of the
specified for the
RatioNumera- input variable.
torAuxiliary input
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
RatioDenomina- input variable.
torAuxiliary input
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
ReferenceType- input variable.
Master input vari-
able to a motion
control instruction is
out of range.
3 Error Descriptions and Corrections
Level
Maj Prt Min Obs Info
S
S
S
S
S
S
S
S
S
Reference
page 3-456
page 3-456
3
page 3-457
page 3-457
page 3-458
page 3-458
page 3-459
page 3-459
page 3-460
3-341